| Most viewed |
An how to of laying Scatters182 viewsStage 2: Middle Layer
Step 1: The next step is to sprinkle a your other colour of scatters on top of the base layer. Put more of one colour in one area than the others to add colour variations to the scene.
Step 2: Then you will have to once again spray with water the scatter - this time from about 1' (30cm) away so as not to disturb them, making sure you thouroughly cover the scatter with water - though dont go overboard.
Step 3: You can scatter on small bits of gravel, and foliage if you wish
|
|
|
An how to of laying Scatters182 viewsStep 3: Next, Sprinkle a layer of scatter, the base scatter you chose earlier. You will need to then use your fingers to gently press this layer into the PVA glue
|
|
|
An how to of laying Scatters182 viewsStep 4: Finally, Mix some White Wood Glue with water at about 10 parts water to 1 part glue. Using the pipette from about 1/16" (2mm) above the scatters, empty the entire pipette onto the scatters (slowly so as not to disturb them). You will see the white glue/water mixture spread out rapidly over the scatters. Repeat this step until you can see clearly a small amount of white/grey on all areas of the scatter.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 1155 files on 58 page(s) |
 |
|
|
|
|
52 | |
|
|
|
|
)
