| Most viewed |
|
Rear Yard Profile206 viewsThe entire yard is on a slope, which is far from idea, as all the trains will roll off onto the mainline.
|
|
|
|
|
Coaling Tipple206 viewsA coaling tipple. I found this one on eBay and thought it would fit in perfectly.
|
|
|
Retaining Wall206 viewsI have built this retaining wall from card and paper which is part of a Scalescenes download which i printed out.
|
|
|
The New River Bed206 viewsThe sandstone mix was spread out into the gorge and then a channel brushed through. The whole thing was then sprayed with watered down glue to bind it all together.
|
|
|
|
|
|
|
|
An Attempt at a River Bed205 viewsI have attempted to make a river bed by glueing fish tank sand onto the river. However i think this looks terrible, and all I have acheived is a solid block of sand paper that i cant cut through >___<
|
|
|
From Below205 viewsA photo taken up through the hole carved for point motors. The holes are alot deeper than they need to be for wiring purposes.
|
|
|
|
|
Cork Roadbed.205 viewsThe profile of the foam trackbed has been leveled and refined, especially around the pointwork (so they lie flat), and to make the gradient changes much smoother. Some areas are up to 15mm thick of cork (most areas are only 1.5mm) - just shows how much I've had to refine my carving.
|
|
|
|
|
Measurement204 viewsTo give an idea of how tight the radius is, this photo proves that its diameter is around 18cm
|
|
|
Start of the lower hill.204 viewsThe bottom section is made of card and packing tape. This will then be modrocked.
|
|
|
Another Check rail204 viewsThere is also a check rail at the tightest Top loop to reduce the risk of derailing.
|
|
|
Hidden Line Clearances203 viewsA shot showing how tight the clearances under the turntable are.
|
|
| 1155 files on 58 page(s) |
 |
|
|
|
|
36 | |
|
|
|
|
)
